[[howto:desktop:play-old-video-games-with-retro-pie]]

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
howto:desktop:play-old-video-games-with-retro-pie [2020-08-13 12:02]
brendan [Display and Speakers]
howto:desktop:play-old-video-games-with-retro-pie [2020-08-13 12:39]
brendan [Launching Games]
Line 123: Line 123:
 <WRAP important>If you have a different model, look for forum posts or videos on the Internet that show where the heat sinks should go.</WRAP> <WRAP important>If you have a different model, look for forum posts or videos on the Internet that show where the heat sinks should go.</WRAP>
  
-For each heat sink, use your fingernail to peel off the packing plastic, then carefully line it up with the appropriate chip (stick side down) and press down firmly for a few seconds to make sure it sticks.+For each heat sink, use your fingernail to peel off the packing plastic, then carefully line it up with the appropriate chip (sticky side down) and press down firmly for a few seconds to make sure it sticks.
  
 {{::heat-sink-1-edited.jpg?240&direct}} {{::heat-sink-2.jpg?240&direct}} {{::heat-sink-3.jpg?240&direct}} {{::heat-sink-4.jpg?240&direct}} {{::heat-sink-1-edited.jpg?240&direct}} {{::heat-sink-2.jpg?240&direct}} {{::heat-sink-3.jpg?240&direct}} {{::heat-sink-4.jpg?240&direct}}
Line 358: Line 358:
 Once you launch a game, you can play it as you normally would. Once you launch a game, you can play it as you normally would.
  
-<WRAP tip>If some of the controls aren't working, consult the [[https://retropie.org.uk/docs/|Retro PIE manual]] for troubleshooting and configuration help.</WRAP>+<WRAP tip>If some of the controls aren't working, consult the [[https://retropie.org.uk/docs/|Retro Pie manual]] for troubleshooting and configuration help.</WRAP>
  
 ===== Quitting a Game ===== ===== Quitting a Game =====
Line 376: Line 376:
 {{::shutdown-1.png?240&direct}} {{::shutdown-2.png?240&direct}} {{::shutdown-3.png?240&direct}} {{::shutdown-1.png?240&direct}} {{::shutdown-2.png?240&direct}} {{::shutdown-3.png?240&direct}}
  
 +After the display goes blank and the internal red power LED on the Raspberry Pi goes out, unplug the Raspberry Pi's power or turn off the power strip that it's connected to. The next time you plug it back in or provide power, it will start back up automatically.